Hi,
was advised to check out your message board so I did.
I am seriously thinking about joining ya'll for your 06/08 run up wheeler pass.
I have an 08 Tacoma v6 acc cab 4x4 with the off road TRD and towing package.
I am having the Leaf Spring TSB job done in house. and upgrading to bilstein 5100s all a round (adj, up front).
I am running stock P265/70R16 rugged trail T/A on all 4 corners but hope to get to a 75R after the suspension parts are in.
I did the toyota trails team event in Big bear earlier this month and intend on going to the United 4 wheel drive assn. 4WD Awareness Class
June 14, 2008 at the Logandale Trails.
I am a union wireman with rigging experiance and have assembled a pretty good recovery kit with both static and kinetic recovery gear.
It includes: 1- 30' 7/8" doublebraid 28K kinetic recovery rope, 1- 50' 1/2" 5.2K & 1-40" 9/16" 11.8K twisted nylon anchor rope. A 150" 5/16 13K amsteel rope w/ eyelet (not pictured). 2-4' purple 5.2K round slings, 1- 10' green 10K round sling & 1 6' red 26.4K round sling (not pictured). As well as 1-5K yellow web sling. Also Included is 1 20' 3/8 7K Q&T drag chain w/ chain hooks. 1 3/8" winching assesory set w/ 3 ton hooks. 1- 48" 7.7K Hi Lift Jack. 2-3.75 ton screw pin shackles, 1 3 ton screw pin shackle, 1 shackled Q&T receiver hitch, 2-48 sq foot hi visability safety netting panels. 1 roll red DANGER ribbon. 1 short handled spade. 1# ball peen hammer, 2 pair leather gloves, 1 pair dyneema working gloves. 2 pair clear safety glasses. 2 hi visability safety vests. 1 flashlight.
This is not my first 4x4 . and I have been stuck more times than I care to mention.
tim
to the board, Tim. Hope to see you out in the dirt soon. BTW, nice recovery gear setup. I've never seen anyone have such a complete setup before. If anyone gets stuck it will sure be nice to have you around 
